Reply to thread

Ugh!!!! Well from what I've read and heard, If you can score a 95' DP, that would be the best way to go as far as size, quality, and accuracy are concerned. Plus you can always bondo up the dent if need be. I hear that the Rubies helmets are very narrow compared to the actual movie helmets and even the DP versions. Could pose problems if you are looking to do custom things in the helmet like adding fans, servos, battery holders, and speakers. Your best bet is to look on ebay for a 95' DP, if not, then I guess a 96' will do, and if I'm wrong, I'm sure a member will correct me and put you on the right path.


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top