Reply to thread

Well I was in the shop painting on helmets the other day and I needed a breather while the paint was drying and just wanted to do something different.  I had some RTV, WED clay and fiberglass suplies so I figured what the heck now is the time to learn how to make a mother mold. Well in between painting I would work on this I used the buck I had obtained earlier. The curiosity was killing me to see how it would turn out as a helmet. I unfortunately casted the ears with it and not separate since I was just goofing around it didn't matter.

I popped it out of the mold and put it on my noggin flashed a pic in the bathroom mirror and as you can see I shot the pic blindly so focus and composition were not a factor LOL. I was pretty happy with the results. After shooting the pic I went back to painting on the helmets. It was something I needed as an intermission to kind of lay the painting down for a brief moment.


I know the question is going to be asked but as much as it pains me I cannot sell any castings. Part of the agreement of me getting this is that I would promise not to sell any castings. And please put yourself in my shoes what else could I say or miss out on it. But anyway on the bright side it's part of the TDH family now.







This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top