Reply to thread

id say dremmel' it or a roto-zip may be easier, especially control in those spaces where u want good contour.. idk, i would think the plastic might not respond cut wise so well with a router as it does with a rotary tool... and a medium to medium/slower speed so they dont get away from ya so easy :cheers


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top