Reply to thread

I've been searching and reading madly about working with sintra - which is what I plan to make my armor out of.  I haven't seen specifically any info about cutting it with a router.


Can the stuff be straight cut?  Beveled?  Rounded over? using a  router?  If so, does anyone have any experince with what cutting speeds work best?


Thanks for the info.


Regards,

Brian


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top