Reply to thread

One of four builds in progress.

 

I'm now using a two part mold for the stock bracket meaning more accurate + less sanding etc. :thumbsup:


SAS


[ATTACH=full]19226[/ATTACH]


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top