Reply to thread

Awsome info! It seems that Kuhnke/ Bucklin parts were used extensively for the fittings as the flamer for the PP2 has a few parts on the tail that have been matched to that company as well. Great info and thank you!


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top