Reply to thread

Message

if done right I don't see why it wouldn't look good. I think if you add 2 pieces of styrene, one to build the other clearance, it should make it so the bottom half wont have to flex and run the possibility of cracking your paint over time. Plastic well should hold fine, when it comes to styrene even plain old super glue holds extremely well. just not the gel kind.

This is knda what I'm talking about.
[ATTACH=full]84120[/ATTACH]

Just put the opposite part of the velcro in the gauntlet top and you should be set.

[QUOTE="GrottyFurball, post: 115985, member: 6878"] if done right I don't see why it wouldn't look good. I think if you add 2 pieces of styrene, one to build the other clearance, it should make it so the bottom half wont have to flex and run the possibility of cracking your paint over time. Plastic well should hold fine, when it comes to styrene even plain old super glue holds extremely well. just not the gel kind. This is knda what I'm talking about. [ATTACH=full]84120[/ATTACH] Just put the opposite part of the velcro in the gauntlet top and you should be set. [/QUOTE]

This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification