Reply to thread

hey every one I'm getting to the point of painting the ee-3 (ROTJ). I'm almost done with the assembly of it and I been looking around here for the steps on painting now.

 Do I first spray it silver then layer the black over it ? then sand edges to give it that weathered look or what ?

 I also need to know what black to use I don't believe its a flat black.

So any help here is appreciated my fellow dent heads.


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top