Reply to thread

Hmmm, it might be a bit tricky, as I look at it. The wide end of the opening is just under 3/4" tapering down to 1/2".

There's room interior-wise ( 1 1/2" to 1".) But fitting it inside it could have to result in cutting the top of w/ a ultra-fine bladed jeweler's saw, inserting Bobo's unit, and gluing it back up. Not an especially imposing task...


That's really all I have to go with, Bobo, what's your measurements?


take care all,


-Rex


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top