Reply to thread

DSyntir,


This can be pretty common without enough layering and reinforcment durring construction of the prop.. I've come across it a few times w/ some of my past gauntlets where the bottom sections would literally split due to flexing :facepalm


It's something that can fixed if your willing to do the layering and reinforcing.


It's one of the main reasons I made rubber cod-pieces pictured below "No breakage" !


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top