Reply to thread

Message

It'll be a challenge with the shape of the cheeks, with the curve and everything they're a pretty strong form to push outwards. Another option would be to sorta reform them, build up the area with bondo or apoxie sculpt to make a shallower cheek, then internally grind/sand the old cheek back. Or alternatively just cut out the old cheeks entirely and rebuild them with sintra or something. But that's a pretty extensive modification at that point. Might be better off just doing a scratch build.

[QUOTE="Grimstuff, post: 488716, member: 8643"] It'll be a challenge with the shape of the cheeks, with the curve and everything they're a pretty strong form to push outwards. Another option would be to sorta reform them, build up the area with bondo or apoxie sculpt to make a shallower cheek, then internally grind/sand the old cheek back. Or alternatively just cut out the old cheeks entirely and rebuild them with sintra or something. But that's a pretty extensive modification at that point. Might be better off just doing a scratch build. [/QUOTE]

This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification