Reply to thread

I should be getting Redman's gauntlets this weekend.  Once I see them I could figure out, but by the way of the 3D printed piano hinges work for all of them.

Please, send me a PM/DM for info to send the files over.  After that, I will post what percentage print they should be printed like ( I completely forgot).


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top