Reply to thread

I know this topic is almost like a year old, but I will take pictures and a link to the G-Code file to print the 3D-printed piano hinges I used with both Mando and Post Sarlacc BF gaunts.  Low profile, and work like a charm.


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top