Reply to thread

Is there any way to weaken JB Weld so it can be removed from metal?

I have a ESB Graflex that had the middle clamp broken (tension bar) and the three parts assembled with JB Weld but want to replace it with a repro clamp.  

 

Should I just leave it as it is because the saber looks fine the way it is and you can't tell it was repaired but it bothers me that "I" know..


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top