Reply to thread

when i've glued snaps onto armor, i've first set the snap into a piece of plastic, then glued the plastic onto the inside of the armor.


it gives a larger surface area for the glue to bond too, which seems to help a lot.


i use either abs cement or goop.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top