Reply to thread


  • Lynn, pasted below is what I plan on using. The buttons are momentary contact. So, you can use one channel for the down of the RF and the other for the up position. I know we're not supposed to post links to ebay, so here's the description and pic of what it looks like below. This should be an easy modification to connect to the contacts in the remote and hard wire to switches into the gauntlet. You will need a battery pack for your relays on the board and the stalk actuator.
    Don




    Details about 12V 10A 2 Channel Remote Control Switch Relay Wireless Transmitter+Receiver
    [ATTACH=full]203595[/ATTACH]


This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top