Reply to thread

Hi all!

Don't have a lot of free time these days with my school schedule, but last weekend

I was actually between projects and had a few glorious hours for myself!  :)


I've had an eFX Luke ANH X-Wing helmet for a few months now.  It's a beautiful

helmet.  Very solidly made, fully lined, and I enjoy having it in my collection.

The only thing (being a detail nut) was that I was never quite satisfied with the

factory weathering job.  It looked OK. . . until I saw a thread over on the RPF that

showed a helmet that was re-weathered by Steve the Swede!

Man oh man, what a difference! 


Since I had some time to do something "proppy" last weekend, I decided that I would

take on a re-weathering job of my own.  It was a fairly simple job.  I used some

tape and plastic to protect the interior, and the visor.  I then shot the whole helmet

with a couple of light coats of Testors dull coat.  I had decided to use pastel powder

to do the weathering and pastels stick to a matte surface much better than a semi-flat

surface.


I don't have any in progress shots, but here are a few of the finished re-weathered bucket.


[ATTACH=full]129848[/ATTACH]


If you're familiar with the eFX X-Wing helmet, the weathering is fairly light overall.  Using

some black pastel powder darkened certain areas nicely.


[ATTACH=full]129849[/ATTACH]


I used a large brush to "pounce" the pastel dust into the surface after getting it approximately

where I wanted it.  Then I used some balled up masking tape with the sticky side out to remove

some of it.  Steve the Swede had some awesome pics up on the RPF that served as a guide for

the weathering patterns.  He's the one who did the paint master for eFX, so what better guideline!


[ATTACH=full]129850[/ATTACH]


Where the patterns were a little more intricate, or where they were scratched down to a brighter base,

I used the back of an X-acto blade to dig through the pastels a little more aggresively.  Most of what I did

was pastel weathering, but there were a few places where I added some chips.  Most noticeably on the red

portions of the helmet.


[ATTACH=full]129851[/ATTACH]


After I was satisfied with the weathering, I sealed the whole helmet with a couple of light coats

of Krylon low odor clear flat. 

So that's pretty much it!  A nice 1-day project for a change.  :LOL 

I really like the way the helmet came out.  Much more grungy than eFX had originally painted it.

Many thanks to Steve for sharing his amazing paintwork and for once again providing inspiration to us

crazy detail-obsessed fans.


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top