Reply to thread

Wow!  Great work on the EE3!   Had no idea this already existed.  Do you scan your original designs or do you design from scratch?  How did you get the checkered pattern on the grips??   Trying to learn the details of solidworks  myself but for the life of me I can’t figure that one out.


This thread is more than 6 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top