Reply to thread

I don't use Cura, but my guess is that it is hollowed out. Typically you have to tell it to print 100% infill to make it solid. Try printing it. You will know quickly if it's hollow or not.


This thread is more than 6 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top