Reply to thread

The 3D model of the Supertrooper/Pre-Pro #1 Flamethrower section of the 10th post was updated with the flamethrower casing, the inner copper parts and the inner aluminum parts models for Shapeways. Here's a simulation of how the parts should fit together:

[ATTACH]210562[/ATTACH] [ATTACH]210560[/ATTACH] [ATTACH]210561[/ATTACH]


This thread is more than 6 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top