Reply to thread

Your best bet then is Shapeways or else scratch build those parts and then print the rest. I thought about printing mine too but my printer is too small (unless I did it in parts) and Shapeways wants some serious $$$ and my suit is on budget...


This thread is more than 6 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top