Reply to thread

For the visor, go to a Harbor Freight store or their website www.harborfreight.com-  They have a little  dremel-like tool for 19.99 or 9.00 on sale, that will fit down in the helmet really well with lots of manuvering room! :) I wish I'd known about these when I cut my two out!


For sanding, Just cut yourself out a miniature sanding block that fits the curve of the inside of the visor.


Good Luck!


-Sarge


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top