Reply to thread

Im redoing my jango fett helmet which use to be a 1st gen cast of a dp deluxe. On the visor area, there is a groove, where Im assumming that the original clipped in. Should I dremel it down or should i bondo it and sand it?

the key is to make sure its even, correct?


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top