Reply to thread

I tried that.  My problem is that I was working on bending two edges at once (doesn't work) I spent all morning going over reference pics and other armor and I think I just bent it too far.  I am going to heat theym up tonight and pull it out a little.  Also I'm going to open up my shoulder bells a little as well.  Other than that, I am ready for bondo, then finish sanding.


Thanks for the input!


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top