Reply to thread

Message

I have a lot of cleaning up to do then some bondo work. I will repour the silicone in the future too. I am totally new with the polyurethane resin so I have a bit of a learning curve to overcome, but as requested, the first pics of the first pull.

[ATTACH=full]84394[/ATTACH]

[ATTACH=full]84395[/ATTACH]

[ATTACH=full]84396[/ATTACH]

Here is the hydrocal original I started with in comparison.

[ATTACH=full]84397[/ATTACH]

It's not the prettiest, but I feel good so far and I am not even close to done, still got the fullsized to finish, mold and casting. Back to work in the basement for me...

-x

[QUOTE="eighteendelta, post: 118706, member: 1867"] I have a lot of cleaning up to do then some bondo work. I will repour the silicone in the future too. I am totally new with the polyurethane resin so I have a bit of a learning curve to overcome, but as requested, the first pics of the first pull. [ATTACH=full]84394[/ATTACH] [ATTACH=full]84395[/ATTACH] [ATTACH=full]84396[/ATTACH] Here is the hydrocal original I started with in comparison. [ATTACH=full]84397[/ATTACH] It's not the prettiest, but I feel good so far and I am not even close to done, still got the fullsized to finish, mold and casting. Back to work in the basement for me... -x [/QUOTE]

This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification