Reply to thread

So I started the mold for the mini. I have a lot of pics, but I am feeling lazy and only uploaded 2 for now, more will follow.


[ATTACH=full]84381[/ATTACH]


I couldn't find any burlap to reinforce my plaster, so I used some of the fiberglass mat and fiberglass cloth that I already have. Not the most economical choice, but it's what I had available.


Here is the dome on and registration groove built up too



[ATTACH=full]84382[/ATTACH]



Just have to lay the plaster on top then break the mold open and start pouring silicone. More to follow, maybe even by the end of today.


There are a lot more pics in my photobucket, knock yourself out if you want to look at them there.


http://s170.photobucket.com/albums/u267/eighteendelta/


-x


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top