Reply to thread

As for sanding after priming, I used 400 grit paper and wet sanded it.  As for the bondo ring- if you can see a ring, then it is not flush, despite how it may seem.  It needs more sanding.  Then when you prime it, if you still see a mark, sand more.  You may need to add a thin layer of bondo further out from the edge of the dent and then sand it down good.


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top