Reply to thread

I may go ahead and try and use my small glue gun and see how it goes. If things go awry, I can bow out and seek help from those kind folks who have offered to help out-and thank you very much for those offers. It's very much appreciated-you have no idea...:)  I was wondering if any of you have seen a small circular threaded sleeve which screws into kind of like a pop rivets head which you insert into the drilled hole and the bottom screws into it? It seems to me that they were used on skateboards at one time but it's been so long ago since those days of skateboarding...I thought that would be a cool solution if some could be acquired. You'd have a secure visor and have the cool riveted look. Go figure, I like the look of some types of exposed rivet or whatever on the visor...


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top