Reply to thread

From what I remember, they are tapered head little bolts that he countersunk in the face then covered over with filler.  I remember something about one of them popping out the face because they weren't glued in before they got covered.  I'd CA glue them in real good.  I remember thinking he was brave for drilling holes in that new (at the time) BKBT.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top