Reply to thread

How did you guys spread the hot glue all at once and have time to set it in place before it hardened? Or did you just do a little at a time starting at the top and working your way down? I think it was Cruzers helmet that had what looked to me to be pop rivets. I'll PM him and see if he can point me towards the parts he used on his. If that fails to help out, I'm not sure what I'm gonna do with the darned thing...


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top