Reply to thread

I saw a helmet recently that looked as if the visor was pop riveted in place rather than using the messy glues and epoxies. After looking at it for a while I started liking the look, if the rivets are set in a uniform manner that is. Have you seen others do this and are there any problems I should look out for other than the obvious? I realize I may have to heat up the visor a bit before I rivet it in place so it doesn't crack it etc...It actually would be alot easier for me due to an issue with my right hand not working and is desensitized quite a bit. I'm always afraid my hand will zig rather than zag and I'll have a visor with quick curing epoxy all over it...I've been ready for the visor for weeks yet keep procrastinating. Perhaps this is a way I can get my bucket completed without rancor...Thoughts?


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top