Reply to thread

Save your self some time and just cut them out of sintra.  Make a couple of long strips the right height.  Sand down the bottom edge of both, and heat and curve one to your main tank.  Then cut them apart and pick out the best ones to glue on.  Oh yeah, mine measure 1/2" tall x 1/4" wide.


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top