Reply to thread

I did toothpaste for my clone, but I think it is a little too striking of a difference for TCW characters.  Kev recommends using pastels to give it a more organic/hand painted look.  I would always use a primer before any other paints go down, after doing a surface scratch with 400+ grit sandpaper and a thorough soap and water washing.  I'm personally using Rustoleum light grey automotive primer, Charcoal Metallic, Sail Blue gloss, Satin White for plastic, and will be top-coating with a satin or matte finish spray (haven't decided yet) once the weathering is done.  I hope this helps!


This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top