Reply to thread

Sand it smooth right down to the white and reprimer it, it wont hurt it. Just dont go to deep or you will get holes in the knee's from fiberglass bubbles under the gealcoat, perfectly normal but just dont go to far, if you do bondo just over them.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top