Reply to thread

I am doing a dp97 conversion to a jango, and i was wondering if i could prime, paint , then cut out and replace the visor.


that wouls minimise the masking on the visor right?

\




any comments?


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top