Reply to thread

Ok, I don't have a helmet liner.  Dont want to go that route.  I am curious about the way you install the padding.  I am using GM's pic for rference only:



How does the material attach to the bucket and stay?  I am also assuming the material is on top of more foam?  I am looking at doing mine about the same, but with black material.  Glue gun?  If so, I have attempted to glue foam into my bucket but it doesn't like to hold to the inside.


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top