Reply to thread

Message

Per your PM, I think I know what you're asking now.

Yes, the "mostly-agreed-upon" width of the lip is 1/8". However, I'm not sure how brittle/flexible the MHK resin material is, so you may have to make adjustments.

On my fiberglass bucket, I sanded the backside of the visor area to 1/8", or close enough. As long as it's uniform and looks good, I think you're okay.

[QUOTE="batninja, post: 21859, member: 229"] Per your PM, I think I know what you're asking now. :) Yes, the "mostly-agreed-upon" width of the lip is 1/8". However, I'm not sure how brittle/flexible the MHK resin material is, so you may have to make adjustments. On my fiberglass bucket, I sanded the backside of the visor area to 1/8", or close enough. As long as it's uniform and looks good, I think you're okay. [/QUOTE]

This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification