Reply to thread

I made my flak vest and applied velcro to everything. It's was looking so good... then I put it on. The armor plates are too flat for my chest and belly.  Does anyone know if fiberglass can be heated and bent? I heard somewhere that it can but I'm not sure if I want to try it. I just bought some sintra so I may just remake it and sell the other set. It would be great for someone not so round:lol: .


-Troy


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top