Reply to thread

I bought some small sharpening files and fine tuned the visor area and vent openings on the back side to near perfection. I added some fiberglass matting under my helmet to cover a hole where the right earpiece goes. Still drying. Next I'll be bondo'ing, filling,and sanding! Thanks Mr. Dwedd for the tips.


I've taken my Jango project out of the backburner. Gonna try and have it done within a couple of months. :D


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top