Reply to thread

Bondo is good for filling cracks.  If you need to bond 2 parts together, head to Walmart and look in the paint supply section (where the masking tape is). 


Find the Super Glue and other glues, and you SHOULD see a "dual tube" of plastic epoxy (the brand name eludes me right now).  It has the resin in one tube, and the hardener in the other.  It's in a syringe-type aplicator.  When you squeeze the end, it dispenses roughly equal amounts of both.  You mix it on something non-porous that you don't mind throwing away (old pice of Sintra or something) for about 30 seconds, then apply it.  It heats up due to the chemical reaction, but it sets in just a few minutes, and from my experiences with it, it ends up being STRONGER than the plastic you're gluing together!  :D


They also sell METAL epoxy by the same company, and the packages and dispensers look VERY much alike.  Make sure you get the PLASTIC epoxy!  ;)


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top