Reply to thread

The best stuff I have found for styrene is Weld On #16 clear, thickened cement for acrylic sheet, made by IPS Corporation.  It chemically bonds the pieces together, meaning it will actually fuse the plastic.  You have to careful using it on very thin styrene as it can soften the plastic too much & cause sink holes.  If this happens, these can easily be filled will filler putty once the glue has cured.


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top