Reply to thread

You'll have to cut off the pin that the post pivots on & glue the earcap in the lowered position.  It should still work fine without the pin because there is an indent for the round part in the helmet & it shouldn't pull out.  If you are worried about this you could reglue the pin or go from the inside of the helmet with a screw to the earcap.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top