Reply to thread

I makeing my Jango helmet from a kit of a 95 Boba. How can i get the right ear peice to look right. It should fit into the lower ear part but that just wont work. What do i do to make that happen?


Eric


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top