Reply to thread

Originally posted by bigkidbiggertoys:


I was just going to use auto pinstriping to do mine after I finished painting and polishing my helmet.  You can get it in different widths and is easily available.  I suppose that if you wanted that "painted look" you could build up a clearcoat over top and block sand it level with say 1500 grit and hit it with a polishing compound after.  Any other ideas out there?


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top