Reply to thread

I assure you that the intensity controls on the anti-security blade are not x-acto handles (in fact that was the first debate I had on the rpf way back when) BUT if you don't want to have the pieces custom machined then x-acto handles work VERY well in their place!


This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top