Reply to thread

Here is how I did it:


First I made a copy of the supplied drawing and cut out and taped it to the blade. Then sanded and filed down to the line on the drawing. I used some temperature curing epoxy I have to glue the disk to the blade, but I think room temp 2 part epoxys should work as well. I did not sharpen the blade, I left it the same thickness.


For the point I first used a hack saw to remove some of the excess material, then used a disk sander to shape it.


For the scallops I just used a standard bastard file.


I used som 400 grit wet/dry sandpaper and wet sanded all surfaces to remove any scratches.



Chris


This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top