Reply to thread

I made a template out of paper, traced it onto 3 mil. sintra, then used a plumbers BLOWTORCH to heat it up and shaped it by hand. Be careful, I had to get it extra hot.

Thanks for the kind words :)


[ATTACH=full]3030[/ATTACH]


This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top