Reply to thread

Ok, here it is.  A few things that I know need reworking, the scope mounts: made my own, they're WAY too large.  Where can i get some MATE-N-LOKs?  anyone got an exact catalog link?  The other problem is the length of the PVC barrel, I'll need to chop a few inches off of that.


The handle/stock connection is secure, but it doesnt look too great.  has anyone come up with a good, cheap way to replicate this?


as always, spare no criticism.



This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top