Reply to thread

I am now finished with the stock and have smoothed out the grooves and nicks with bondo glazing putty. Now all that has to be done is cleaning up the trigger.:D

http://200.72.163.179/cdref/tdh/Blaster/sbr14.jpg


This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top