Reply to thread

thats a GREAT looking blaster:D...one question reguarding the hose clamp heat shrink method: did you use shrink tubing that was slightly larger than the clamp and then applied heat, or did you simply just find a piece that just fit snug over the clamp?


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top